Monday, 20 April 2015

LIQUID



  Q Which of the following statements about the pressure at a point in a liquid is  not   correct.

            A   it acts equally in all direction
            B   it increases when the depth increases.
                        C   it increases when the density increases
            D   it depends on the shape of the container.

Q         The density of liquid X  is  1 000 kg m-3 .What is the pressure in Pascal (Pa) exerted by the liquid 10 m below the surface ?

            A     10
            B     100
            C     1000
            D     100 000
            E     1 000 000 


Q      A mixture of gas and air is produced by a bunsen burner. This can be explained by
        
         A      Archimedes’ principle
         B      Bernoulli’s principle   
         C      Pascal’s principle
         D      the principle of conservation of momentum 


Q    The wall of a dam is much thicker at the bottom than at the top because

         A    pressure of water at the upper level is higher than pressure of water at the deeper level
         B    pressure of water at the upper level is lower than pressure of water at the deeper level
         C    pressure of water at the upper level is the same as than pressure of water at the deeper
                level


Q.      Which of the following can be done to increase the kinetic energy of gas molecules in an
            air-tight container?

A         Increase the volume of the container.            
B         Decrease the volume of the container
C         Increase the temperature of the container.     
D         Decrease the temperature of the container.

Q      Which of the statements shows the applications of high pressure in everyday life?
        
A      A knife with a sharp edge
B      A bulldozer with a wider tyre
C      Tall buildings on a base of large surface
D      Snow shoes with a larger surface area
        
Q.    Which of the instruments applies the Pascal’s principle?

A      Lift pump
B      Hydrometer
C      Bunsen burner
D      Hydraulic Jack


No comments:

Post a Comment